The Photon Micro-Light II with its easy-to-use dual function switch (easy squeeze and continuous on) is ready for any event. With its super tough glass-filled polyurethane case and unbreakable LED it is built to be used for a lifetime. Whether you're climbing Mount Everest or simply walking to your car, the Photon II will easily illuminate your path. Due to our quality and use of cutting edge technology, both the Secret Service and NASA space shuttle crews have chosen Photon Micro-Light for their missions.
Photon Micro-Light II Operating Instructions:
Operation of the Photon II is fairly straight-forward. For momentary use or signaling, simply squeeze the button to turn the light on. As soon as the button is released, the light will turn off. For continuous use, slide the small clear plastic switch back (towards the key ring end of the light) to lock the light on.
Operational Tips:
The switch will slide much easier when NOT squeezing at the same time.
If the light flickers, gently wipe leads with a soft tissue being careful not to distort their shape. For minor cases, sometimes the mechanical action of simply pressing and releasing the squeeze button several times is enough to eliminate a flicker.
For a snappier switch: disassemble the light and carefully raise the lead (wire) 25-30 degrees and reassemble (see instructions below).
--------------------------------------------------------------------------------
Photon Micro-Light II Battery Replacement:
Depending on the beam color, your Photon II will use either a pair of lithium CR-2016 batteries (white, green, NV green/turquoise, blue, & purple) or a single CR-2032 lithium battery (red, orange, yellow, & infrared). Replacement with CR-2016 batteries pictured below.
Remove four screws from bottom of the Photon and flip case over so switch is on top. Note: Press firmly with screwdriver to avoid damage to screw or driver tip.
Carefully separate top and bottom case.
Remove clear slide switch.
Hold bulb down with one finger and lift lead (wire) just enough to remove batteries.
Important! Do NOT change bulb leads except for raising enough to replace batteries.
Install new battery(s).
Replace slide switch on slightly raised lead.
Position top case so slide switch extends through hole and close case.
Flip over and replace screws.
*For best performance we recommend Energizer brand replacement batteries.
--------------------------------------------------------------------------------